Matériel de l'association » ShapeOko

Configuration GRBL

==================

Nos réglages :

$0=30 (step pulse, usec)

$1=65 (step idle delay, msec)

$2=244 (step port invert mask:11110100)

$3=66 (dir port invert mask:01000010)

$4=0 (step enable invert, bool)

$5=1 (limit pins invert, bool)

$6=0 (probe pin invert, bool)

$10=66 (status report mask:01000010)

$11=-2147483.648 (junction deviation, mm)

$12=2147483.648 (arc tolerance, mm)

$13=0 (report inches, bool)

$20=0 (soft limits, bool)

$21=0 (hard limits, bool)

$22=1 (homing cycle, bool)

$23=153 (homing dir invert mask:10011001)

$24=500.000 (homing feed, mm/min)

$25=100.000 (homing seek, mm/min)

$26=10 (homing debounce, msec)

$27=0.000 (homing pull-off, mm)

$100=87.221 (x, step/mm)

$101=87.221 (y, step/mm)

$102=643.087 (z, step/mm)

$110=5000.000 (x max rate, mm/min)

$111=5000.000 (y max rate, mm/min)

$112=500.000 (z max rate, mm/min)

$120=250.000 (x accel, mm/sec^2)

$121=250.000 (y accel, mm/sec^2)

$122=100.000 (z accel, mm/sec^2)

$130=0.000 (x max travel, mm)

$131=0.000 (y max travel, mm)

$132=-0.000 (z max travel, mm)