Configuration GRBL¶

Nos réglages :
$0=30 (step pulse, usec)
$1=65 (step idle delay, msec)
$2=244 (step port invert mask:11110100)
$3=66 (dir port invert mask:01000010)
$4=0 (step enable invert, bool)
$5=1 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=66 (status report mask:01000010)
$11=-2147483.648 (junction deviation, mm)
$12=2147483.648 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=153 (homing dir invert mask:10011001)
$24=500.000 (homing feed, mm/min)
$25=100.000 (homing seek, mm/min)
$26=10 (homing debounce, msec)
$27=0.000 (homing pull-off, mm)
$100=87.221 (x, step/mm)
$101=87.221 (y, step/mm)
$102=643.087 (z, step/mm)
$110=5000.000 (x max rate, mm/min)
$111=5000.000 (y max rate, mm/min)
$112=500.000 (z max rate, mm/min)
$120=250.000 (x accel, mm/sec²⁾
$121=250.000 (y accel, mm/sec²⁾
$122=100.000 (z accel, mm/sec²⁾
$130=0.000 (x max travel, mm)
$131=0.000 (y max travel, mm)
$132=-0.000 (z max travel, mm)